Specification of 7 inch Round Led Headlights
Type: Headlight
Size:7 inch
Power:58W (Hi- beam-58W,Lo- beam-35W)
Housing Material: Die-cast Aluminum
Lens Material:PC
Waterproof: IP65
Color Temperature: 6000K (White)
Operating Voltage: DC 12V/24V
Lumen:Hi--5800lm,Lo--3600lm
Life-span: Above 100,000Hours
Product Images
Advantages of 7 inch Round Led Headlights
- Projector Lens High Low Beam
High-definition optical material, strong penetration, spotlight
- High Brightness
Brightness is 3 times of the halogen lamps
- Light Sensitivity
Light is softer to prevent from glare
- High Energy Saving
Reduced energy consumption by at least 50% (low energy consumption means low fuel consumption)
- Long Lifespan
High quality LED chips have a long lifespan which is more than 50,000 hours
- Waterproof
Highly sealed connector, waterproof rate IP67, anti-corrosion, protect the headlights from bad various environments
- Die-cast Housing
Aluminum housing, corrosion resistant, fast heat dissipation to extended lamp lifespan
- Easy to install
Plug and play, easy to install, does not damage the original car electrical system
Morsun Led Headlights are designed to use for aftermarket replacements for Jeep Wrangler and motorcycles, our high quality led headlights make sure your Jeep Wrangler and motorcycles are ready for the road and trails. These led headlights for Jeep Wrangler and motorcycles are built with shatterproof and waterproof IP67 projector lens, they can be used in a variety of environments.
We pride ourselves as one of the leading manufacturers and exporters of high quality led headlights for Jeep Wrangler and motorcycles with reasonable price. With our high quality Jeep Wrangler led headlights our customers are getting a higher quality light output comparing with the original ones. In addition, the unique aluminum housing is designed to be waterproof, anti-corrosion and fast heat dissipation to extend the lifespan of the headlights. Our headlights have 12 months warranty which means we will provide our best service in warranty period so that you never need to worry about using our lights.
Quality Control
- Raw material inspection
- Chip mounting
- Check PCB electrical parameters
- Put heat-conducting silicone grease and PCB into the housing
- 2 hours aging test of the semi-finished product
- Assembled optical component dust removal and cleaning
- Check electrical parameters and optical correction
- Assembling lens by machine
- Lens fixture
- 2 hours aging test and vacuum pumping to solve inside fog problem
- Laser logo
- Packing and shipping
Exhibition
